Loading...
HomeMy WebLinkAboutCertificate of Compliance - 72 SAW MILL ROAD 7/30/2013 PUBLIC HEALTH DEPARTMENT Town of forth Andover Community Development Division CERTIFICATE COMPLIANCE As o : 7/30/2013 This is to certify that the individual subsurface disposal system received a SATISFACTORY INSPECTION of the; Repair By: Todd Bateson At 72 Saw Mill Road Map 104A Lot 0085 North over The Issuance this certificate shall not be construed as a guarantee that the system will function satisfactorily. ;Su'��"a wye Aeath. A nt 1600 Osgood Street,North Andover,Massachusetts 01845 Phone 978.688.9540 Fax 978.688.8476 Web www.townofnorthandover.coni e ' North Andover Health Department Community Development Division QNSITE WASTEWATER Y T CONSTRUCTION NOTES LOCATION INFORMATION ADDRESS: 72 Saw Mill MAP: 104A LOT: 0085 INSTALLER: Todd Bateson DESIGNER: PLAN DATE: BOH APPROVAL DATE ON PLAN: INSPECTIONS TANK INSPECTION: 7/30/13 D-Box DATE OF BED BOTTOM INSPECTION: DATE OF FINAL CONSTRUCTION INSPECTION: DATE OF FINAL GRADE INSPECTION: SITE CONDITIONS ❑ Contractor reports any changes to design plan ❑ Existing septic tank properly abandoned ❑ Internal plumbing all to one building sewer ❑ Topography not appreciably altered Comments: SEPTIC TANK ❑ Building sewer in continuous grade, on compacted firm base ❑ Cleanouts per plan ❑ Bottom of tank hole has 6" stone base ❑ Weep hole plugged ❑ 1500 gallon tank has been installed H-10 loading ❑ Monolithic tank construction ❑ Water tightness of tank has been achieved by visual testing ❑ Inlet tee installed, centered under access port ❑ Outlet tee installed, centered under access port (gas baffle/effluent filter) ❑ inch cover to within 6" of finish grade installed over one access port ❑ Hydraulic cement around inlet & outlet Comments: PUMP CHAMBER ❑ Bottom of tank hole has 6" stone base ❑ Weep hole plugged ❑ 1500 gallon Pump Chamber installed ❑ H-10 loading ❑ Monolithic tank construction ❑ Inlet tee installed, centered under access port ❑ Pump(s) installed on stable base ❑ Alarm float working ❑ Pump On/Off floats working ❑ Separate on/off floats ❑ Drain hole in pressure line ❑ cover at final grade installed over pump access port ❑ Watertightness of tank has been achieved by testing ❑ Hydraulic cement around inlet & outlet Comments: CONTROLPANEL ❑ Alarm & Pump are on separate circuits ❑ Alarm sounds when float is tripped ❑ Location of control panel: basement ❑ Alarm signal located inside: basement Comments: DISTRIBUTION-BOX X Installed on stable stone base X H-20 D-Box ❑ Inlet tee (if pumped or >0.08'/foot) X Hydraulic cement around inlet & outlets ❑ Observed even distribution X Speed levelers provided (not required) Comments: Called Neil — adjust speed levelers on left side